This installation instruction cover model : 8010, 8010TK, 8030, 8030TK, 8040, 8040T, 8040TK FORD ‘99 to current Super Duty F250, F350, F450, F550 and Excursion with stock power mirrors. Tools required for the installation are: 7/16″, 5 mm & 9/32″ sockets, a small screwdriver, electrical tape and a sharp tool for cutting a hole for the in/out switch. For the TK models you will also need a volt meter.
Removal of existing mirror :

• Remove the trim panel on both doors (note – Ford doors do not have retaining clips located around the doors as other models have). To remove the door panels, start by removing the panel on each side window. Remove the plastic panel that holds the electric windows and door locks (to remove this panel pry up from the front or tip of the panel). After you have removed the plastic panel, unscrew the 9/32″ screw seen in the back of the hole. Remove the plastic cover from the door light. Behind the plastic cover remove the 9/32″ nut head (See diagram 1 on page 4). To remove the door panel, lift up and unplug the door light. The plastic panel that holds the switches for the door locks and window switches can be moved down through the hole that it rests on. To unplug the stock mirrors, remove the speakers on each door using a 5 mm socket (make sure that each window is in the down position before unplugging the electric window socket). The mirror connector is behind the speaker.
• While supporting the mirror, use a 7/16 socket to remove the 4 nuts that hold the stock mirror in place. The 4 stock nuts will not be reused.
• Remove the stock mirror.

Download PDF Ford Stock Mirror Installation Instruction