This document is the Manual Installation of KLEEMANN Comfort Power COMPRESSOR KIT V8 apply for MERCEDES-BENZ ENGINE 113. These fitting instructions constitute a helping hand for the installation of the Compressor System. It is recommended to read the instructions before installing the kit, so that you can gain an overview of the entire installation before you begin. Dismount Steps : – The plastic cover over the engine. – The intake pipe between the throttle body and air filter box, including the airflow meter. – The clip holding the water hose near the oil filter. – The wiring harness connections to: EGR valve, Ignition coils, injectors, Throttle body, The manifold adjustment valve. – All vacuum connections to the intake manifold, throttle body, brake booster, and fuel
line. – The intake manifold. – The knock sensor wires (disconnect the plug and run it under the water hose at the
left rear cylinder head, and reconnect). – The accessory belt. Remove the idler pulley that sits at the highest point of the engine. The long bolt holding this idler pulley will be used again. – Install new spark plugs – Use only Kleemann certified spark plugs – Empty the cooling system.