Under Dash Warning Lights Installation. To determine the proper installation location for the warning light you are installing, choose a location that allows you to see the warning light during normal operation of the car. Generally, the Parking Brake Warning Light will be near the brake release handle and the Seat Belt Reminder Light will be under and to the right of the ignition switch. You may choose to mount an additional Seat belt reminder l…
Porsche 928 S4 Dash Removal Step : 1. Remove Horn Pad. With Steering Column Lowered, grab both sides and pull really hard, the pad will flex then pop out of the three mounts. The horn connector will probably pull off as the pad is removed, put a bit of insulation tape on it, just in case. 2. Remove Steering Wheel : 27mm Socket and a universal joint required. 3. Remove Diagnostic Plug Cover : Two thumbscrews on either side, Rear hatch Release butt…
This installation manual shows you how to remove your Honda Civic door panel. You can do it yourself if you have the necessary equipment and follow this door panel installation instrutions. Remember to use the appropriate tool from the KTC trim tool set to avoid damage when removing components and take care not to scratch the door or related parts. Special Tools Requirement : – KTC trim tool set SOJATP2014 – Trim pad remover, Snap-on A 177A or eq…
Volkswagen Passat B5 Instrument Panel Installation. This step by step manual installation complete with picture apply for Volkswagen Passat B5 shows you how to remove and installing the instrument panel. The installation and removal procedure : – Remove center console – Remove airbag unit driver side 38 – Remove hex head bolt -2- (60 Nm – must be replaced) – Place steering wheel-1- in center position (wheels straight…
These steps are guidelines to help you install your new Mustang product. Mounting Suggestions for the Harley-Davidson® Softail Wide Tire (200 mm) FXST 2006-2009, FLSTF Fat Boy 2007-2009 & FLSTSB Cross Bones 2008-2009 Tank Bib. Mounting of Mustang Tank Bib : 1. Remove seat then with a 1/2″ wrench, loosen the dash acorn nut and remove the lower panel screw. 2. Lift back of dash approximately 1/2″, then slide panel down off of the t…
