… length of wire to connect (short) pins 7 and 19 for 3-5 seconds with the ignition key in position 1 (Accessory). B. After Mid-2000: You should not have the 20-pin DLC connector. You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it …
…nalization items. Find themes to customize your BlackBerry smartphone at Shop Themes. AT&T Music provides the ultimate, integrated, on-the-go music experience. AT&T Music will connect you to music with a touch of a button. Your use of the camera application on your BlackBerry Bold 9000 may be prohibited or restricted at certain times. Use the camera application responsibly and abide by all applicable laws, rules and regulations. To cons…
This document is a flow chart to assist you in diagnosing vehicle vibrations. Follow from top to bottom to help isolate the source of the problem. Contents : Set tire pressures to vehicle manufacturer’s inflation pressures and road test – Is vibration noticed through steering wheel or through seats/floor? – Through steering wheel – start with front axle – Through seats/vehicle floor – start with rear axle – Wha…
…e service indicator may be reset using the reset mode in the instrument cluster. Reset procedure for high and low clusters with SIA III using the Reset Mode: Ignition key must be “off”. Press and hold the trip odometer reset button in the instrument cluster (left button), and turn the ignition key to the first position. Keep the button pressed for approximately 5 seconds until one of the following words appear in the display: “OIL SERVICE, or “IN…
…30 up to MY2007 (SL-Class), Model 230 (SL-Class from MY2008 to Present), Models 164, X164 and 251 (M-Class, GL-Class, and R-Class). Reset Service Indicator step : 1. Insert key into ignition, switch to position “1“. 2. Press buttons or repeatedly until the mileage is displayed within the Multifunction display. 3. Press cluster illumination button (1) 3 times in short succession. The battery voltage will be displayed and an audible signal will sou…
